English | Persian

 شما اينجا هستيد: صفحه آغازين » محصولات » شارژرهاي باطري

 

شارژرهاي باطري صنعتي / منابع تغذيه DC

In these devices, output DC voltage can be controlled by using a semiconverter or fullconverter circuit.

In The first category a single device should charge the batteries and supply the load in parallel. In the second category, DC power system consists of two independent Battery chargers and a distribution panel. At a time only one device should be in service and the other should be in standby state.

These converters are produced in two categories:
Single Battery chargers
Double Battery Chargers
Electrical Specification

The control circuit doesn’t permit two devices to work in parallel. The control system has been design to give the capability of manual and automatic selection of chargers. In the automatic mode, the chargers change their state every 24 hours. A microprocessor based electronic circuit fulfills all the control functions of the devices and a LCD panel gives the capability of programming device by operator, so the best algorithm could be selected for charging batteries .

Industrial Battery Charger

Functional Overview

Industrial Battery Charger Capability of working in four charging modes:
     Automatic, Initial, Boost, Float
Programmable via an LCD panel
Adjusting of charger voltage depending on battery temperature
Operational measured values of voltage and current
Converter output current limit
Battery charge current limit
Soft starting
High / Low DC fault detection
AC fault detection
Earth fault detection
High temperature detection
Charger fail detection
Protection of reverse battery connection
Short circuit Protection
RFI suppression upon request

Type: TTC, TSM

Electrical Specification
AC Input Voltage
Input Voltage: 3PH, 380V ± 10%
1PH, 220V ± 10%
Input Frequency: 50HZ ± 5%
DC Output Voltage
Nominal Voltage: 12, 24, 48, 110 VDC
(Other voltages upon order)
Nominal Current: 0 - 1000A
Voltage regulation: < 1%
Ripple voltage (p - p): < 2%
(Without Battery)
Ambient condition
Temperature 0 - 50 °C
Altitude 2000m Above Sea Level
Humidity 0 - 90%
Mechanical Specification
Frame Free Standing & Wall Mounted
Color RAL 7032, Powder Coated
(Other RAL's upon order)
Entry Bottom
Cooling System Natural Air Cooling
Protection Degree IP21 - IP41
 

براي دريافت اطلاعات فني بيشتر لطفا برگه درخواست اطلاعات را تكميل و ارسال فرماييد:

برگه درخواست اطلاعات فني

بالا

 

Industrial Battery Charger

 

Industrial Battery Charger